!
Ethernet has become the industry standard network connection, and
it is the most common method currently used to connect a Macintosh
to a QMS printer. An Ethernet port is built into your
magicolor
330
Print System and most current Macintosh computers.
»
Note:
If you want to print via LocalTalk, refer to the
Options
manual
for information on installing an optional LocalTalk interface.
1
1
Refer to chapter 4, “Connecting to an Ethernet Network” for
connection information.
2
If your network has more than one zone, use the Administra-
tion/Communications/Resident NIC/CrownNet/EtherTalk/
Zone Name/Zone Part 1 and Zone Part 2 menus to enter the
name of the zone to which the printer is attached.
»
Note:
The two Zone Part x menus allow you to identify 1 zone
with a name up to 32 characters long. (Up to 16 characters can
be entered in each of the two menus). You cannot use these
menus to identify two separate zones. Trailing spaces are not
considered part of the zone name. All standard printable ASCII
characters are valid except the @ and ' symbols. The names are
case sensitive.
3
You’re now ready to print.
From this point, you’ll probably perform most printing tasks from
your application. For specific information, check the printing sec-
tion in your application documentation.
For information on print media types and sizes, see chapter 2,
“Print Media,” in the
Reference manual
.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
