nord NORDAC START Series, User Manual

Page: 55 / 120

3 Display, operation and options
BU 0135 en-4118 55
3.1.1 Control and parametrisation units, use
Access to the parameters of the SK 1x5E can take place either using the NORD CON software or with
the aid of an optionally available SimpleBox or ParameterBox. Permanent parameter changes must be
saved in the Flash memory of the device using parameter P550 .
A SimpleBox or ParameterBox cannot be connected directly to the device, but must be connected
using an RS 232 / RS 485 converter (SK TIE4-RS485-RS232, Part No. 275274603). When doing this
the parametrisation unit must be connected to the converter before making the connection to the
motor starter. The motor starter must be ready for operation when this takes place.
Information
Status LED DS
With active RS232 communication to the PC (NORD CON) or to a connected parametrisation unit, the status of
the device cannot be indicated via the LEDs. In this case, the "DS" LEDs signal that communication activity is
taking place by being permanently on in green. The red LED is then switched off.
The green LED can also be made to flash by adjusting potentiometer
P1 .
Figure 7: SK CSX-3H / SK PAR-3H / SK TIE4-RS485-RS232 (l-r)
Module Description Data
SK CSX-3H *)
(handheld SimpleBox)
Used for commissioning, parametrisation,
configuration and control of the device.
4-digit, 7-segment LED display, membrane key
IP20
RJ12-RJ12 cable (connection to the device 1)
SK PAR-3H *)
(handheld ParameterBox)
Used for commissioning, parametrisation,
configuration and control of the device
(only in ControlBox mode) and its options
(SK xU4-…). Entire parameter data sets
can be stored.
4-line backlit LCD display, membrane
keyboard
Stores up to 5 complete parameter data sets
IP20
RJ12-RJ12 cable (connection to device)
USB cable
(connection to PC)
* Also required:
Converter
SK TIE4
-
RS485-
RS232
Connection extension for the conversion
of the RS485 signal of the parametrisation
units SK CSX-3H or SK PAR-3H to the
RS232 signal of the starter
Data sheet
TI 275274603
( www.nord.com )
IP20
Cable RJ12-RJ12 (connection to device /
option)
Part No. 275274603