NORDAC FLEX (SK 200E ... SK 235E) – Users Manual for Frequency Inverters
250
BU 0200 en-US-4920
Pos : 740. 1 / Anleit ungen/El ektr onik /FU und St art er/8. Z usatzinform ati onen/EM V/ Elek trom agnetisc he Verträglichkeit (EM V)_(Übersc hrift) @ 0\mod_1328187595765_14638. docx @ 15186 @ 2 @ 1
8.3 Electromagnetic compatibility (EMC)
Pos : 740. 2 / Anleit ungen/El ektr onik /FU und St art er/8. Z usatzinform ati onen/EM V/ Elek trom agnetisc he Verträglichkeit (EM V)_Einl eitungst ext [ SK 1x xE, SK 2xx E, SK 5xxE, SK xxxE-FD S] ] @ 0\mod_1325780630565_14638.docx @ 14812 @ @ 1
If the device is installed according to the recommendations in this manual, it meets all EMC directive
requirements as per the EMC product standard EN 61800-3.
Pos : 740. 3 / Anleit ungen/El ektr onik /FU und St art er/8. Z usatzinform ati onen/EM V/ _Allgem eine Bestimmungen [all e FU + St art er] @ 5\mod_1396880662665_14638. doc x @ 124647 @ 3 @ 1
8.3.1 General Provisions
As of July 2007, all electrical equipment which has an intrinsic, independent function and which is sold
as an individual unit for end users, must comply with Directive 2004/108/EEC (formerly Directive
EEC/89/336). There are three different ways for manufacturers to indicate compliance with this
directive:
1. EU Declaration of Conformity
This is a declaration from the manufacturer, stating that the requirements in the applicable
European standards for the electrical environment of the equipment have been met. Only those
standards which are published in the Official Journal of the European Community may be cited in
the manufacturer’s declaration.
2. Technical documentation
Technical documentation can be produced which describes the EMC characteristics of the device.
This documentation must be authorized by one of the “Responsible bodies” named by the
responsible European government. This makes it possible to use standards which are still in
preparation.
3. EU Type Test Certificate
This method only applies to radio transmitter equipment.
The devices only have an intrinsic function when they are connected to other equipment (e.g. to a
motor). The base units cannot therefore carry the CE mark that would confirm compliance with the
EMC directive. Precise details are therefore given below about the EMC behavior of this product,
based on the proviso that it is installed according to the guidelines and instructions described in this
documentation.
The manufacturer can certify that his equipment meets the requirements of the EMC directive in the
relevant environment with regard to their EMC behavior in power drives. The relevant limit values
correspond to the basic standards EN 61000-6-2 and EN 61000-6-4 for interference immunity and
interference emissions.
Pos : 740. 4 / Allgem ein/ Allgemei ngültig e Module/---------Seitenumbr uc h k ompakt --------- @ 13\m od_1476369695906_0. doc x @ 2265496 @ @ 1
