17
Dual Trigger Tools
Tools purchased with a Dual Trigger Module (DTM) pre-fitted are identified with the part number suffix .DTM
Tools purchased with a DTM pre-fitted are calibrated at Norbar with the DTM in place. This is because the
DTM itself creates a pressure drop which would alter any previously determined calibration data.
WARNING:
IF A TOOL IS PURCHASED WITH A DTM FITTED (AS A DTM TOOL) AND
THE USER WANTS TO REMOVE THE MODULE AND USE THE TOOL
WITHOUT IT, A NEW CALIBRATION IS REQUIRED. IN THIS SCENARIO
CONTACT NORBAR OR YOUR NORBAR DISTRIBUTOR.
With the DTM fitted the tool will not operate unless both the trigger on the DTM and the tool trigger are
pressed simultaneously.
As with the tool trigger, the DTM trigger must be fully pressed so as not to affect the air flow, pressure, and
ultimately the torque output.
FIGURE 7
– Dual Trigger Module
Summary of Contents for PNEUTORQUE PTM series
Page 25: ...24 NOTES ...
