NorAM 65ET T4 FINAL, Operator'S Manual

Page: 30 / 194

1
NORAM 65ET GRADER
2-20
General Infor
mation
2
Component Identification and Locations
Front Console Lock Lever
Lever
(1)
prevents the movement of the implement,
moldboard, articulation and wheel lean levers, and front
console.
All levers must be in a neutral position to engage
implement lock. The console must be tilted forward to
allow the implement lock to engage.
Horn
The horn is used to signal others of impending movement
or operation of the grader. To activate the horn, push end
of Multi-Function Switch
(1)
in.
Headlights and Taillights
To activate the taillights, turn the end
(1)
of the Multi-
Function Switch one notch counterclockwise. To activate
the taillights and headlights, turn the end of the switch
fully counterclockwise (two notches). To turn off
headlights and taillights, turn end of the Multi-Function
Switch fully clockwise.
High beam is activated by pushing the switch forward
(2)
. To return to low beam, pull the switch rearward
(3)
and release. To flash the high beam, pull the switch
rearward and hold. High beam will be activated until the
switch is released.
Turn Signals
To activate turn signals, move Multi-Function Switch up
(4)
to signal a right turn or down
(5)
to
signal a left turn. When the turn has been completed, move Multi-Function Switch to center position.
NOTE:
Multi-function Switch does not automatically return to OFF position after turning.
1
1