NORAM 65ET GRADER
4-43
Lubrication and Maintena
nce - Grader Compon
ents
4
When Required
Parking Brake Switch - Adjust / Replace
The parking brake switch
(1)
sends an electronic signal
to the transmission that keeps the transmission from
shifting into gear, or causes the transmission to shift out
of gear.
When the cable is replaced or adjusted at the lever end,
the switch operation should be verified and adjusted, as
necessary.
1. Remove top place
(2)
.
2. Remove storage box
(3)
3. Loosen the retaining bolts
(1)
on the switch mounting
plate
(2)
.
4. Pull the brake lever up to the third notch.
5. With the ignition switch in RUN, slide the parking
brake switch up or down until the parking brake lamp
appears on the display. Tighten the retaining bolts on
the switch mounting plate.
6. Release the parking brake lever. Verify that the parking brake message appears between the 2nd
and 3rd notch.
7. Replace cover and storage box.
Radiator / Oil Cooler - Check
Check radiator/oil cooler for debris and restrictions. Remove louvered side panels and rear radiator
cover and blow compressed air (not to exceed 207 kPa {30 psi}) from the back of the motor grader into
the engine compartment. This is the opposite direction of normal air flow.
Wear safety glasses or goggles when cleaning with compressed air.
2
3
Summary of Contents for 65ET T4 FINAL
