A
CCESS
G
ATEWAY
52
Installing the Access Gateway
Enter write/set community [private]:
Enter IP of trap recipient [0.0.0.0]: 10.11.12.13
SNMP Daemon: Enabled
System contact:
System location: Office, Newbury Park, CA
Get (read) community: public
Set (write) community: private Trap recipient: 10.11.12.13
Reboot to enable new changes? [yes/no] y
Rebooting...
You can now address the Access Gateway using an SNMP client manager.
Configuring the WAN interface
If a license key is not present, you will still be directed to set up the WAN configuration as soon as you log
into the CLI. However, the subsequent steps are new and network settings are no longer configured under
Location.
The following are the steps needed to configure the main WAN interface:
1.
Enter
c
(configuration) at the
Access Gateway Menu
. The
Configuration
menu appears.
2.
Enter
eth
(ethernet).
3.
After you have entered “yes” to the initial prompt, enter “mod int WAN” or “m i WAN” (“modify
interface WAN”). Note that modes and interface names are case sensitive. The configuration then steps
through the settings one by one.
4.
Port role for the WAN port should be already set to WAN, just hit <enter>
5.
Set the configuration mode to match your network settings.
6.
Set the remaining network settings .
7.
Default uplink and download speed is 15 Mbps. Enter different values if desired.
8.
Bandwidth and DNS settings are configured separately for each WAN interface. You can configure them
later in the WAN configuration dialog in the Web Management Interface.
9.
If you do not wish to configure additional NAT IP addresses at this time, type “b”.
10.
A summary of the WAN port settings is now displayed; if they are correct, type “b” again.
You will now see the Nomadix location configuration page. Enter contact data and agree to the Nomadix End
User License Agreement. Your license will be retrieved when you enter “y”. The NSE will then reboot to
activate your license settings.
Summary of Contents for AG 2300
Page 1: ......