4.3.3
Transmit optical output
The maximum transmit optical output of an ONT is +5 dBm.
4.3.4
Normal laser operation
In normal operation, fiber cable laser radiation is always off until it receives signal from the line
terminal card.
Operating personnel must observe the instructions on the laser explanatory label before plugging in
the optical module.
DANGER
Hazard
Risk of eye damage by laser radiation.
4.3.5
Location class
Use cable supports and guides to protect the receptacles from strain.
4.4
Electrical safety guidelines
This section provides the electrical safety guidelines for the ONT equipment.
Note:
The ONTs comply with the U.S. National Electrical Code. However, local electrical
authorities have jurisdiction when there are differences between the local and U.S. standards.
Figure 4-6
Sample laser product safety label on the ONT equipment
18532
3FE55851ABAA
Model:
MFG:
MONTH: XX
YEAR: XXXX
ICS: XX
MRev: XX
MAC:XXXXXXXXXXXX
SN:ALCLXXXXXXXX
FCC ID: XXXXXXXXXXX
This device complies with Part 15 of the FCC Rule.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including intereference that may cause undesired operation.
ASSEMBLED IN CHINA
2301 Sugar Bush Rd.
Raleigh, NC 27612
DANGER - Invisible Laser radiation when open.
AVOID DIRECT EXPOSURE TO BEAM.
DANGER - Rayonnement Laser invisible lorsqu’elle
est ouverte. Evitee l’expostion direct au faisceau.
Complies with 21 CFR 1040.10 and 1040.11 except for deviations
pursuant to Laser Notice No. 50 dated June 24, 2007
12VDC
3A
I.T.E
Intertek
4006119
CLASS 1 LASER PRODUCT
PRODUIT LASER DE CLASSE 1
ANSI ONT safety guidelines
Electrical safety guidelines
Nokia ONT
Review
Review
© 2021 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3FE-49546-AAAA-TCZZA
December 2021
40
Issue 1