Nokia RoofTop R240, User Manual, Page: 29 / 139

FCC Rules and Regulations - Part 68
This equipment complies with Part 68 of the FCC Rules. The FCC Part 68 Label is located on the rear panel of the Network/
Power Unit unit. This label contains, among other information, the FCC Registration Number and Ringer Equivalency Number
(REN) for this equipment. You must, upon request, provide this information to your telephone company. The REN is useful to
determine the quantity of devices you may connect to your telephone line and still have all those devices ring when your
telephone number is called. In most but not all areas, the sum of the RENs of all devices connected to one line should not
exceed five (5.0). To be certain of the number of devices you may connect to your line, as determined by the REN, you should
contact your local tele-phone company to determine the maximum REN for your calling area.
Connection to the telephone network should be made by using standard modular telephone jacks, type RJ11. The plug and/or
jacks used must comply with FCC Part 68 rules. If your telephone equipment causes harm to the telephone network, the
telephone company may discontinue your service temporarily. If possible, they will notify you in advance, but if advance notice is
not practical, you will be notified as soon as possible. You will be informed of your right to file a complaint with the FCC.
Your telephone company may make changes in its facilities, equipment, operations or procedures that could affect the proper
functioning of your equipment, If they do, you will be notified' in advance to give you an opportunity to maintain uninterrupted
telephone service.
This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subject to
tariffs.
If trouble is experienced with this unit, for repair or warranty information, please contact customer service at the address and
phone listed below. If the equipment is causing harm to the network, the telephone company may request that you disconnect
the equipment until the problem is resolved.
DO NOT DISASSEMBLE THIS EQUIPMENT. It does not contain any user serviceable components. Attn: CUSTOMER
SERVICE DEPT.
Compliance in Canada
Canadian compliance (Industry Canada) When tested with at least one intended host: This digital apparatus does not exceed
the Class B limits for radio noise emissions from digital apparatus set out in the interference-causing equipment entitled "Digital
Apparatus", ICES-003 of the Canadian Department of Communications.
Cet appareil numérique respecte les limites bruits radioélectriques applicables aux appareils numériques de Class B prescrites
dans la norme sur le matériel brouilleur: "Appareils Numériques", NMB-003 édictée par le Ministre Canadien des Communica-
tions.
Notice: The Industry Canada (IC) label identifies certified equipment. This certification means that the equipment meets tele-
communications network protective, operational and safety requirements as prescribed in the appropriate Terminal Equipment
Technical document(s). The department does not guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecom-
munications company. The equipment must also be installed using an acceptable method of connection. The customer should
be aware that compliance with the above conditions may not prevent degradation of service in some situations.