Figure 53
Rx Control
window
• Set AGC Mode to Algorithm.
• Set Channel to 10700.
• Set AFC Algorithm to OFF (Default = OFF).
Next actions
When settings are ready, click Start to activate them.
If settings are changed later on (for example, you give a new channel number), you will need to click Stop
and Start again.
Note:
Clicking Stop also disables Tx Control if that was active!
WCDMA RSSI measurement
Prerequisites
WCDMA Rx must be activated before RSSI can be measured. See
WCDMA Rx chain activation for manual
Steps
1. Start
Phoenix
service software.
2. Choose Testing
→
WCDMA
→
Rx Power Measurement .
3. In the
Rx Power Measurement
window, choose the following settings:
• Mode: RSSI
• Continuous Mode
RM-132; RM-133
RF Troubleshooting and Manual Tuning Guide
Nokia Customer Care
Issue 1
COMPANY CONFIDENTIAL
Page 7 –13
Copyright © 2006 Nokia. All rights reserved.