Nokia IP561, Installation Manual, Page: 80 / 96

Replacing Other Components
80 Nokia IP561 Security Platform Installation Guide
Replacing the Battery
To replace the battery, you need the following:
„
The appropriate Nokia battery replacement kit for your appliance
„
Physical access to the appliance
„
A Phillips-head screwdriver
„
A grounding wrist strap
„
(Optional) Safety glasses
Warning
An explosion might occur if the battery is incorrectly placed. Replace the battery only with
the same or equivalent type that the manufacturer recommends. Dispose of used batteries
according to the manufacturer’s instructions.
Warning
Make certain to remove the power cord from the appliance before you proceed with any of
the following steps. Failure to do so could cause electric shock with burns or death resulting
for the user.
Caution
Make certain that you are properly grounded when you handle components internal to
the appliance to protect against electrostatic discharge damage to the appliance. Use
the grounding strap included in the battery replacement kit.
To install the battery, perform the following tasks:
1. Use Nokia Network Voyager or the command-line interface (CLI) to perform an orderly
shutdown of the IP561.
For information about how to access Network Voyager and the related reference materials,
see
“Using Nokia Network Voyager” on page 40.
2. Turn off the power to the IP561 appliance.
3. Loosen the front panel retaining screws.