Nokia IP561, Installation Manual, Page: 55 / 96

Two-Port Fiber-Optic Gigabit Ethernet NIC
Nokia IP561 Security Platform Installation Guide 55
Figure 17 Gigabit Ethernet Crossover Cable Pin Connections
To connect the IP561 to other network components, you can order appropriate adapter cables
separately from a cable vendor of your choice.
Two-Port Fiber-Optic Gigabit Ethernet NIC
The IP561 supports Nokia-approved, two-port, fiber-optic Gigabit Ethernet NICs installed on a
PMC expansion slot. The IP561 can accommodate up to four Gigabit Ethernet NICs.
When you purchase a Gigabit Ethernet NIC with your IP561, the NIC is installed before the
appliance is delivered to you. For information about how to add or replace a NIC, see
Chapter 4,
“Installing and Replacing Network Interface Cards.”
Multi-Mode Fiber-Optic Gigabit Ethernet NIC Features
The MMF fiber-optic Gigabit Ethernet NIC supports:
„
High bandwidth
„
Full-duplex mode operation up to 1 Gbps (no half-duplex support)
„
Link speed auto advertising
„
Compliance with IEEE 802.3z Gigabit Ethernet specification
The MMF fiber-optic Gigabit Ethernet NICs in the IP561 run on Nokia IPSO-VN v4.1 or higher.
You can configure and monitor Gigabit Ethernet NIC interfaces with Nokia Network Voyager.
Specifically, you set the port speed and full-duplex mode with Network Voyager.
For information about how to access Network Voyager and the related reference materials, see
“Using Nokia Network Voyager” on page 40.
00020
1
2
3
4
5
6
7
8 1
2
3
4
5
6
7
8