2.
Plug the RJ11 cable into the set's UA port/phone line connector.
3.
Connect the RJ11 cable to a UA port in the telephone system.
8.6.1.2.3 Programming keys
This section describes how to program the programmable keys.
In fact, only the direct call key can be programmed (with a telephone number), which by default is the
sixth programmable key. However, the Personal/Dial by name key can be programmed in a similar way.
To program a key:
1.
Press the
i
key followed by the required programmable key.
2.
Press one key of the 2-way navigator (up or down).
3.
Enter the telephone number to be associated with this programmable key.
4.
Press
OK
. The set then goes back to its default display.
8.7 V24/CTI Interface Module
8.7.1 Hardware description
8.7.1.1 Overview
The V24/CTI Interface Module allows a Data Terminal Equipment (DTE) to be connected to the OXO
Connect, via a UA link, by means of an RS232 serial link (CTI port) or a V24 link.
The V24/CTI Interface Module can be used alone or combined with Digital Premium DeskPhones.
CTI port
The RS232 serial link carries signalling (up to 9600 bit/s) and allows telephone operations such as call
management and call monitoring. The audio part is carried out by the associated dedicated set.
V24 port
The V24 port is considered as a DCE and provides a capacity of 19200 bit/s (ECMA 102) for an
asynchronous V24 transmission. The electrical interface complies with the V28 recommendation of the
CCITT.
V24/CTI
Interface Module
UA link
UA link
CTI
UA
UA
V24
CTI: up to 9600 bit/s
V24: up to 19200 bit/s
DCE
DTE
or
PCX
UAI Board
(or MIX board)
9 Series Set
Figure 8.7: V24/CTI Interface Module Configuration Example
Chapter
8
Device commissioning
8AL91217USAA - Ed. 01 - July 2018 - Installation Manual
141/216
