Nokia 500s, Installation Manual

Page: 37 / 136

Before You Begin
Nokia 500s Installation Guide 37
To ground the 500s appliance
1.
Locate and remove from the package the #6 ring tongue lugs and kep
nuts.
2. Attach a 10 or 12 AWG insulated grounding cable to the lugs.
3. Locate the two threaded grounding studs protruding from the rear panel of
the appliance, as shown in
Figure 7 on page 29.
4. Slide the grounding lug loops over each of the studs.
5. Secure the grounding lugs by threading the nuts onto each of the studs
until they are tight. You can use an adjustable wrench or similar tool to
finish tightening the nut onto the stud. Do not over tighten the nuts.
6. Attach the grounding cable to an earth ground or other grounding point to
meet the specifications of your installation site.