RM-583
Antenna Description and Troubleshooting
Introduction
RM-583 includes two internal antennas. One is for cellular frequency bands and this internal antenna assembly
adopts PIFA Antenna structure for the cellular engine, the other is for Bluetooth module, a PIFA antenna too,
Visual quality requirements
Below are the minimum acceptable visual quality requirements of the internal antenna assembly:
z
Wear gloves to assemble the antenna. Don’t touch the antenna radiator with bare hands.
z
No visual cracks or mechanical defects.
z
No oil, dirt or particles attached on the parts.
z
Radiator must be flat without warping and aligned with the plastic housing.
z
The length of all pins must be identical and the pins align.
Failures and corrective measures
The two antennas are assembled into B Cover as shown in Figure 1. If no internal antenna is installed, the
antenna gain is degraded by more than 20 dB.
z
If the internal antenna is missing, install antenna-asm Module.
z
If the radiator is damaged, replace it with a new antenna-asm Module.
Figure 1: B Cover Assembly
COMPANY CONFIDENTIAL
Copyright © 2009 Nokia. All rights reserved.
Page 5-5
Issue 1
