48
5.3 REPLACING OF THE PUMP STATION
STEP 1:
After removing the handle, remove 4
screws of the cover, then take out it.
STEP 2:
Remove the pipe joint of the pump with
24mm wrench.
STEP 3:
Remove the cable FP fixing the
contactor and cable E2 fixing the motor. Then
remove cable 5-4-1.J1-4- of contactor coil.
Watch out for the hydraulic oil
spilling, check if the joint is dirty and clean it.
STEP 4:
Remove 2 screws fixing the pump
station with 6mm wrench.
STEP 5:
Lift the pump up ,then you can remove it.
