2
1
3
5a.
5b.
8
5
4
6
1.
Screw parts
1
to part
2
, using the
M8 screws and nuts included in
the packaging.
2.
Screw vertical part
3
to the
above parts.
5.
In case of two collectors model, place the collector supporting part
5
on bottom part and between the gaps of the
parts we place the four collectors’ fixing washers
8
without tightening the M8 screws with the nuts. In case of one
collector model you don’t need to use part
5
. The collector is going to be fixed with the 2 collectors’ fixing washers
8
as it is described at the 5a and 5b balloons.
3.
Screw diagonal part
4
to the above parts
and tighten all screws. Repeat steps 1, 2 &
3 for the other pairs of parts.
4.
Place parts
6
crosswise
and tighten the screws.
SUPPORT BASE ASSEMBLY ON A FLAT SURFACE
Solar water heaters
25
24
Solar water heaters - AELIOS
Solar water heaters - AELIOS
