User Manual N11
Cleaning
Industrial PC
www.noax.com
Page 86 of 120
3085-US-2.4
13.1.1 Devices with PCAP touchscreen
The glass surface of the PCAP touchscreen can be cleaned with a commercially avail
able glass cleaning agent. Wipe the glas dry after cleaning.
For correct function the glass surface of the PCAP touchscreen has to be free from any
residues. (see general cleaning information on section 13.1.)
If necessary redo the cleaning of the PCAP touchscreen and finally switch off the
display with the [ On / Off ] key, wait a second and switch on the display with the
[ On / Off ] key again.
13.2
Touchscreen cleaning mode
When touchscreen cleaning mode is activated, the Industrial PC touchscreen and
control keys are deactivated for a set period of time. This allows the user to take the
time to clean the device even during operation, without the risk of accidentally trigger
ing actions. This cuts out the time‐consuming process of shutting down and
restarting the Industrial PC.
The touchscreen cleaning mode of the Industrial PC can be launched either via the
nSMART™ software or for some Industrial PC types with a key combination
using the
control keys.
13.2.1 Starting cleaning mode with nSMART™
Touchscreen cleaning mode can be started through the nSMART™ software in the
“Touchscreen” section.
For further information on this, see Chapter 11.8
The yellow
(Input) LED will flash as confirmation that cleaning mode has been
activated.
The touchscreen surface can now be cleaned. When it is touched, no data will be sent
to the operating system.
13.2.2 Starting cleaning mode with a key combination
Not possible with device types S15 and P15
See Chapter 10.7 for information about starting the touchscreen cleaning mode with
key combination. Here, touchscreen cleaning mode will be started without time limit.
The yellow
(Input) LED will flash as confirmation that cleaning mode has been
activated.
The touchscreen surface can now be cleaned. When it is touched, no data will be sent
to the operating system.
