NKT Photonics Koheras ACOUSTIK, Product Manual, Page: 51 / 96

51
Enabling emission from an individual BASIK module
Procedure 5 Enabling emission from an individual BASIK module
Action
1 Connect to the ACOUSTIK system using the procedures in Communicating with the
ACOUSTIK .
2 Select the module to enable; click on its icon
in the Device Selector or the Module
Overview panel (see Module overview ).
When a single BASIK module is selected, the
control and status panels display indicators
and controls for the selected module only.
NOTE: Koheras BASIK controls are described
in the NKTP document:
Koheras BASIK Product Guide
3 Ensure the front panel key switch is set to the
ON position.
4 Observe the Interlock indicator in the status
panel , if it is RED and the Status indicator is
AMBER, check for the following conditions:
a The door interlock circuit is open –
Connecting the safety interlock
b The external bus is not looped back with a
bus defeater –
Connecting the safety
interlock
c The key switch is set to OFF – return to
step 3.
ON
Status panel of the
selected
Control panel
selected module
with slot #
Click the
module icon
module
displays the
ON
OFF
Interlock: ON RED
Status: ON AMBER