User manual – Glass Clock Design #3
rev 1.2
5.5.3
Setting the time - hours
When the hours (leftmost) digits are blinking, the hour value can be
changed.
The black function button on the left side will change the hour value
when pressed. Holding the function button on will quickly cycle
through the hours (0-23). Note: When setting the hours, 24 hour
mode is used, regardless of the hour format setting (12/24 hour
display mode). This means '00' is 12 AM (midnight), and '13' is 1 PM
(afternoon).
Once the hours are set to the proper value, press the red mode button
(right side) momentarily. The clock will then go to the minutes set
mode.
5.5.4
Setting the time – minutes
When the minutes (middle) digits are blinking, the minutes value can
be changed.
The black function button (left side) will change the minute value
when pressed. Holding the function button on will quickly cycle
through the minutes (0-59).
After the hours are set correctly, momentarily press the red mode
button (right side). At this point, all the digits
(Hours:Minutes:Seconds) will flash once a second. Pressing the mode
button again will update the alarm time to the new settings.
Page 13 of 27