Gemini Two Tube Clock
16
Update #1 (21
st
May 2019)
www.nixology.uk
Push 4 x socket pins on to the pins that you just soldered and push the complete
assembly in to the PCB from the Underside.
Solder the pins and remove the Buck Converter. When re-fitting, make sure that
you have the buck converter the correct way around, 12V ‘IN’ towards the outer
edge of the PCB.
Alternative SPACE SAVING method:
This
MUST BE DONE
AFTER
soldering R1, R2, R3, R4 and the 8 pin DIL
socket in to place
If you would like to reduce the overall height of the clock then use the four
single pins (supplied as a 1x4 way header pins that you can cut in to 4 individual
pins) by soldering the ‘short’ ends to the Buck Converter.
Mount the Buck Converter on the underside of the PCB taking care to mount it
the right way around the solder in to place from the top side of the PCB.