Nivus OCM F, Instruction Manual

Page: 49 / 110

Parameter Setting
OCM F - rev. 05 / 06.04.2018 page 49
and >down< to jump across two lines up or down at each key action.
To complete the name of the measurement place use the four arrow
keys and confirm your selection with >ENTER<. The cursor subse-
quently will jump one digit to the right enabling you to choose the next
character.
Surplus or incorrect characters can be overwritten by entering a blank
which can be found top left in the table.
In order to modify an existing name move the input cursor right by
simultaneously pressing the >right< + >down< or >up< arrow keys.
Press >left< + >down< or >up< to move to the left.
1
Current name of the measurement place
2
Selected character
3
Selection list
Fig. 23-3 Setting the name of the measurement place
The >right< or >left< arrow keys can be used to move the cursor even
after the cursor reaches the right or left margin of the table. Pressing
the >right< or >left arrow keys once again after the input cursor has
reached the right or left table margin will move the cursor one more
step in the desired direction.
Press ESC to finish the measurement place name entry:
>Save new
values< Saves the input
>Back< Enables corrections
>Cancel< Aborts the input and the previous name will
be kept
Fig. 23-4 Accepting the new measurement place name
>Profile< You can select between following standard profiles according to
ATV A110 (dimensions to be entered in brackets):
-
Round pipe (diameter)
-
3r Egg (radius)
-
Rectangular (profile height and width)
-
U-Profile (profile height and diameter)
-
Trapezoid (profile height, profile width down/up, max. chn. height)
-
Custom shape h/A (channel shape(s))
-
Custom shape h/b (channel shape(s))