Instruction manual
NivuSonic Clamp on
®
8.5.1 Parameter Menu „ Measurement Place“
Fig. 8-14
Submenu measurement place
The menu cannot be indicated completely due to restricted display space. Simi-
lar to many well-known PC applications, this is readily identifiable from the black
bars on the right-hand side of the screen.
Use "Up“ and "Down“ keys to scroll the menu
Name (of measure-
ment place)
NIVUS recommends to coordinate and to define names according to names
stated in the respective documents. Names may contain up to 21 letters. Setting
the name is quite similar to operating a mobile phone:
After the submenu >Name< has been selected the basic setting “nivus“ will
come up. Toggle between uppercase and lowercase letters by using the >up<
or >down< keys.
Pressing the "Alt“ key will either turn on or off a selection of special characters.
The special characters can be selected individually with the >left< or >right<
arrow keys, confirm your selection with “Enter”.
Fig. 8-15
Setting the name of the measurement place
Enter the desired name with the keypad, where each key has assigned three let-
ters and a number (see Chapter 7.2). Select between these four characters by
briefly pressing a key several times. The cursor will jump to the next character if
a key has not been pressed for two seconds.
NivuSonic CO - Rev. 00 as of 08.12.2010
Page 55
Summary of Contents for NivuSonic Clamp On
Page 109: ...18 Declaration of Conformity...
Page 110: ......
