14
[3]
When the measurement value is larger than the lower limit value or lower than the upper limit
value, the GOOD lamp is turned ON.
When the measurement value is larger than the upper limit value or lower than the lower limit
value, the NG lamp is turned ON.
[4]
When the measurement is finished, press the “UP” key when you save the numeric value, and
press the “CLEAR” key when you restore 0 to the display value. At this point, the lamp and
buzzer used for the judgment result are turned OFF.
* If you do not use the judgment function, set 0 to the upper limit value and lower limit value,
or set a larger value to the lower limit value than the upper limit value.
6--9. Maximum, minimum, and average values calculation function
You can display and check the maximum value, minimum value, average value, and number of data of
the measurement values.
Up to 30 data can be calculated. If the number of data exceeds 30, the oldest data is deleted, and new
data is calculated.
(1)
How to measure maximum value, minimum value, and average value
[1]
Check if the measuring mode is “PP” or “PD”.
[2]
Press the “AVE” key. “AVE” is blinking at the bottom of the liquid crystal panel.
[3]
Perform the torque measurement. Press the “UP” key when you add the numeric value in the
calculation, and press the “CLEAR” key when you clear the numeric value and set 0 to the
display value. Repeat this operation.
[4]
After the measurement is finished, press the “AVE” key to display the number of the data,
maximum value, minimum value, and average value.
[5]
The number of the data (no display at the bottom of the liquid crystal panel), maximum value
(“MAX” at the bottom of the liquid crystal panel), minimum value (“MIN” at the bottom of the
liquid crystal panel), and average value (“AVE” at the bottom of the liquid crystal panel) are
displayed in this order on the liquid crystal panel.
* When you measure new maximum value, minimum value, and average value, the previously
saved data become invalid.
6-10.
Recharging
(1)
Automatic power-off
This product will power itself off if it is left for 10 minutes or if the battery level is low.
(2)
Battery charger
The battery has a limited life span. If you find that it only lasts for an extremely short time after fully
charged, or if you find any similar problem, please consult the shop where you bought the product.
(3)
How to recharge the battery
When the battery level on the liquid crystal panel is low, insert the connector of the supplied battery
charger to the “DC IN” terminal to charge the battery. The charge is finished when the lamp next to
the “DC IN” terminal turned OFF, and the battery level on the liquid crystal panel is full.
Note
Overcharge may cause a battery burst, heat-up, or leak, resulting in a fire or injury. As a battery
charger, always use a DLE1833A
CONTAINS NICKEL-METAL HYDRIDE
BATTERY.MUST BE RECYCLED
OR DISPOSED OF PROPERLY.
This product uses a nickel-metal hydride battery. Nickel-metal hydride batteries are a recyclable,
precious resource. If you find that it only lasts for a short time after a full recharge, consult the shop
where you bought this product.
(4)
How to replace the plug of the battery charger
How to install the plug for Japan and the US (A type) and the plug for Europe (C type)
[1]
Slide the circled part of the plug mounted on the battery charger in the arrow direction.
[2]
You can remove the plug by sliding the circled section.
[3]
You can mount the A type or C type plug to the battery charger with the plug removed.
Note When you use the battery charger in Japan, be sure to use the A type plug.
Summary of Contents for delvo DLT1173A
Page 2: ......
