Remember to read the NTS805 Series Operation & Safety Manual for detailed
procedures of troubleshooting, tool assembly, disassembly and cleaning.
Check the thickness and type of base material before fastening. Follow your
In fastening into steel substrate, the minimum thickness of substrate must
be 3/16".
W W W . N I T R O S E T . C O M
NTS805 Series Quick Start Guide
Always wear proper safety e uipment including safety glasses, hard hats,
hearing protection, and gloves while operating the tool.
Required Safety & Protective Equipment
Minimum concrete thickness is three times the fastener penetration
(ie. 3" of concrete base material is a minimum requirement for 1"
penetration).
Check Before Fastening
The NITROSET® tool is for fastening into the following base materials only:
Concrete
Structural Steel
Never
attempt to fasten into any material other than those listed above.
Acceptable Base Materials
1
Adapter Installation
Note:
As illustrated above, Nosepiece Gasket is inserted in the groove of the
Muzzle. Debris Cup Gasket goes between the Muzzle and Debris cup. The Red
Adapter is installed between the Muzzle and Reset Sleeve.
Muzzle
Debris Cup
Gasket
Nosepiece
Gasket
Red
Adapter
Debris Cup
Red
Adapter
Reset
Sleeve
Muzzle
Debris Cup
Note:
As illustrated above, the Red Adapter is installed between the Muzzle
and Reset Sleeve.
Red
Adapter
Reset
Sleeve
Muzzle
Debris Cup
Note:
As illustrated above, the Red Adapter is installed between the Muzzle
and Reset Sleeve.
