(7)
MIC. Output Connector :
Please use an interconnector cable that is compatible with your
transceiver.
output connector are available separately for “Kenwood/Yaesu” and “Icom” transceivers.
Cable
for Amateur Radio Transceivers
KENWOOD
: NS-73K, NS-24K
ICOM
: NS-73K, NS-24I
YAESU
: NS-73Y, NS-24Y
“
24 type
”- 8 pin Round connector.
73 type
– Western connector (RJ connector)
(8)
FM/SSB Selector Switch
:The selector switch for microphone output audio quality.
When FM mode operation, it produces clear voice quality with wide frequency
characteristics and when in SSB mode operation, it produces sharp and
crisp voice quality for effective “DXing”.
(9)
Selector For Output
K
ENWOOD/YAESU : For
KENWOOD
or
YAESU
.
ICOM
:
For
ICOM
ONLY
(10)
Output Adjustment Volume
: This is the adjustment volume for output voltage. It is
factory-adjusted to have 10mV RMS Output voltage. When you need
adjustment, turn the slot of variable resistor with a 3mm wide screw
driver slowly and carefully. Turn to clock-wise for higher output.
Please be sure to make this adjustment at the Compressor Level Switch
(9), “HIGH” position.
(11)
Battery Cover
: Remove the COVER and put the 2 pieces of UM3 batteries into the space
correctly.
(The
batteries are not provided with this microphone.)
CAUTIONS
:
Please be sure to use Interconnection microphone cable optionally available.
When using a external power adaptor, please be sure to use our external power adaptor optionally
available.
Please be careful about high SWR of antenna and incomplete earthing, since it may cause the trouble of
RF feedback noise depending on coaxial cable layout.
Please turn the power switch “OFF” after QSO.
It is better to remove batteries from microphone when you do not use the microphone over than 3
months.
Do not place this microphone near high temperature area or under direct sunlight.