NIMO PRO FT 120 VP, User Manual

Page: 43 / 52

ENGLISH
43
Placement/mounting
See Figure K and L
The drying cabinet must be level on an even surface
and rest on all four feet.
Adjust the four adjustable feet from the outside with a
17 mm wrench. Make sure that the upper edge of the
doors are in line and level.
Securing to the wall
The cabinet must be
secured to a wall
to prevent it
from tipping.
The mounting kit has two angle brackets that should
be mounted on the top part of the drying cabinet in ac-
cordance with the illustration. Use the supplied screws.
The brackets have grooves to adjust them to the wall.
Fasten the cabinet to the wall. The mounting kit includes
screws and Rawlplugs.
The drying cabinet must not be placed in an environ-
ment where pressure washers are used.
The drying cabinet is only intended to be placed
indoors in a dry location.
WARNING!
The drying cabinet must not be used wit-
hout securing it to a wall due to the risk of it tipping.
Electrical connection
See Figure N
1 Connection to mains
Connection to the mains must be made via all-pole
switch to 400V 3N AC 50Hz.
Total output 2.3 kW.
Fuse 10A slow, 10A automatic fuse.
Make sure that the connecting current corresponds to
the data on the type plate and that the main power
line is grounded correctly in accordance with current
standards. We recommend that the mains supply is
provided with a
residual current device.
The manufacturer will not accept any liability if the
electrical connection has not been done in accor-
dance with the description in this manual.
The electrical connection must be done by a certified
electrician
The electrical connection of the appliance must
comply with applicable electrical safety regulations.
Connection to floor drain
See Figure O
The cabinet is supplied from the factory with an outlet
connection for condensation on the left-hand side.
The
connection can be moved to the right-hand side
according to the instructions in the Service Manual.
Thread the condensation hose supplied onto the angle
coupling and route it to the drain.
Thread on the hose without a hose clip.
The assembly kit contains 3 m hose.