^SICA: 3,1
^SICA: 4,0
^SICA: 8,0
If the
AT^SICA
command does not work, the terminal will respond with
#ERROR
or
AT^SICA?
will respond with:
^SICA: 3,0
Check the signal strength with
AT+CSQ
to verify the Skywire is getting an
acceptable signal. Otherwise, consult the Nimbelink AT Command Manual for
Firmware 4.3.2.0.
2.15.5.
NL-SW-LTE-WM14
APN Configuration:
In the terminal program, type the command:
AT%PDNSET=1,"APN","IP"
where
APN
is the individual APN for your network, followed by the Enter key, and
the terminal program should respond with:
OK
Note: Consult Section 3: APN Setup for help with your APN.
To verify that the APN was set correctly, in the terminal program type the
command:
AT%PDNSET?
followed by the Enter key, and the terminal should respond with:
%PDNSET: 1,APN,IP,,,,,0
as well as the other PDP context information on the device.
Further setup may be necessary. Check the signal strength with
AT+CSQ
to
verify the Skywire is getting an acceptable signal. Otherwise, consult the Telit AT
Command Reference Guide for your particular modem.
2.15.6.
NL-SW-LTE-QBG96 APN Configuration:
In the terminal program, type the following command:
AT+CFUN=0
The terminal should respond with:
OK
The above command disables cellular functionality, and deactivates any
previously activated PDP contexts. Next, enter the command below to configure
the APN:
PN 30005 rev 23
© NimbeLink Corp. 2019. All rights reserved.
22