followed by the Enter key, and the terminal should respond with:
+CGDCONT: 3, “IP”, “Verizon APN”
as well as the other PDP context information on the device.
To enable this setting, in the terminal program type the command:
AT#SGACT=3,1
followed by the enter key, and the terminal should respond with:
#SGACT: www.xxx.yyy.zzz
where
www.xxx.yyy.zzz
is the Skywire modem’s IP address.
If the
AT#SGACT
command does not work, the terminal will respond with
#ERROR
and further setup may be necessary. Check the signal strength with
AT+CSQ
to
verify the Skywire is getting an acceptable signal. Otherwise, consult the Telit AT
Command Reference Guide for your particular modem.
2.15.4.
NL-SW-LTE-GELS3 APN Configuration
In the terminal program, type the command:
AT+CGDCONT=3, “IPV4V6”, “Verizon APN”
where
Verizon APN
is the specific APN to connect to for your intended use,
followed by the Enter key, and the terminal should respond with:
OK
Note: Consult Section 3: APN Setup for help with your Verizon APN.
To verify that the APN was set correctly, type the command:
AT+CGDCONT?
followed by the Enter key, and the terminal should respond with:
+CGDCONT: 3, “IPV4V6”, “Verizon APN”
as well as the other PDP context information on the device.
To enable this setting, in the terminal program type the command:
AT^SICA=1,3
followed by the enter key, and the terminal should respond with:
OK
To verify that the APN is correct, type the command:
AT^SICA?
followed by the enter key, and the terminal should respond with:
^SICA: 1,1
^SICA: 2,0
PN 30005 rev 23
© NimbeLink Corp. 2019. All rights reserved.
21