To enable this setting, in the terminal program type the command:
AT#SGACT=3,1
followed by the enter key, and the terminal should respond with:
#SGACT: www.xxx.yyy.zzz
where
www.xxx.yyy.zzz
is the Skywire modem’s IP address.
If the
AT#SGACT
command does not work, the terminal will respond with
#ERROR
and further setup may be necessary. Check the signal strength with
AT+CESQ
to
verify the Skywire is getting an acceptable signal and the network registration
with '
AT+CEREG?'
to confirm the modem has registered. Otherwise, consult the
Telit AT Command Reference Guide for your particular modem.
2.15.3.
NL-SW-LTE-TSVG APN Configuration
Users have two options for setting up PDP Context on the CAT3 LTE Skywire
TM
.
Use the VZW network to pull the proper APN:
In the terminal program, type the command:
AT#OTAUIDM=0
followed by the enter key, then wait for #DRELL response from the terminal.
Next, type the command:
AT+CGDCONT?
Read the response from the terminal and see what 3rd PDP context changed to.
The second method is to manually set the APN provided by VZW.
In the terminal program, type the command:
AT#SCFG=3,3,300,90,600,50
followed by the Enter key. The terminal should respond with:
OK
This is configuration information for setting up the context in the next step.
In the terminal program, type the command:
AT+CGDCONT=3, “IP”, “Verizon APN”
where
Verizon APN
is the specific APN to connect to for your intended use,
followed by the Enter key, and the terminal should respond with:
OK
Note: Consult Section 3: APN Setup for help with your Verizon APN.
To verify that the APN was set correctly, type the command:
AT+CGDCONT?
PN 30005 rev 23
© NimbeLink Corp. 2019. All rights reserved.
20