12
FLOORTEC 350
146 3083 000(2)2008-11 A
ENGLISH
USER MANUAL
SIDE BROOM HEIGHT CHECK AND
ADJUSTMENT
Check the side broom distance from the
fl
oor as shown
1.
below:
Drive the machine on a level ground and lower the side
•
broom.
Keep the machine stationary and turn on the side
•
broom for a few seconds.
Turn off the side broom by pressing the switch (1), then
•
lift it and move the machine.
Check that the side broom print is as shown in the
•
fi
gure (A, Fig. 1): the side broom must touch the ground
along a circle arc ranging from “10 o’clock” position to
“3 o’clock” position.
If the print is not within speci
fi
cations, adjust the broom
•
height as shown in step 2.
Turn the knob (13) clockwise and counter-clockwise to
2.
adjust the broom height.
Perform step 1 again to check the proper adjustment of the
3.
side broom height.
When the broom is too worn to be adjusted, replace it as
4.
shown in the next paragraph.
SIDE BROOM DISASSEMBLY/ASSEMBLY
CAUTION!
It is advisable to wear protective gloves when
replacing the side broom because there can be
sharp debris between the bristles.
Drive the machine on a level
fl
oor.
1.
Turn the main switch (1) to “0”.
2.
Lift the side broom.
3.
Loosen the knob (A, Fig. 2) inside the side broom, then
4.
remove the broom (B) by disengaging it from the pins (C).
Install the new broom on the machine engaging it on the
5.
pins (C), then tighten the knob (A).
Adjust the height of the new broom according to the
6.
procedure shown in the previous paragraph.
10
3
A
S311350
Figure 1
B
C
A
S311351
Figure 2
All Parts available from
www.sparesgiant.com
01772 329 565