Side Broom System
198
Service Manual – Floortec R 870
Lowered Right Side Broom Enabling Sensor Disassembly/Assembly and
Adjustment
Disassembly
1
If possible, place the machine on a hoisting system.
2 Remove the right side broom
3
On the right front lower side of the machine, unscrew the locknut (A) and remove the enabling sensor
(B) from its housing
4
Disengage the sensor electrical cable (C) from its fasteners, then disconnect the relevant connector.
5 Retrieve the enabling sensor (B) with the electrical cable
Assembly and Adjustment
6
Place the enabling sensor (B) and connect its connector, then engage the wiring harness from its
fasteners
7
Screw down the locknut (A), without tightening it.
8 Turn the side broom lifting/lowering lever to lower the brooms
9
Adjust the distance (D) between the sensor (B) and the pin (E) to 4±1 mm, then tighten the locknut (A).
10 Install the right side broom
C
B
A
B
E
D
4±1mm
A
4±1mm
P200193