Electrical and Control System
56
Service Manual – Floortec 760
Battery Installation and Battery Type Setting (WET or GEL) (Floortec 760 B) (Continues)
Battery Removal
1 Drive the machine on a level floor and ensure
that it cannot move
2 Turn the ignition key to “0”
3 Remove the hopper by using its transport handle
and wheels
4 Disengage the front fastener and open the
battery compartment hood
5 Disconnect the battery connector
6 Disengage the guards (A) from the battery
terminals
7 Disconnect the battery terminals
8 Carefully remove the batteries (B)
Battery installation
1 Install on the machine the type of batteries
which is compatible with the setting of the
machine; for checking the setting of the machine
or to change it, refer to the procedure described
below
2 Route and install the battery cables, then
carefully tighten the nut on each battery
terminal
3 Engage the guards (A) on the battery terminals
4 Connect the battery connector
5 Close the battery compartment hood and engage
the front fastener
6 Install the hopper on the machine, by using its
transport handle and wheels
P200313