GENERAL INFORMATION
SERVICE MANUAL
ENGLISH
Micromatic
TM
M17B - Micromatic
TM
M17E
9097091000(1)2007-06
3
Do not operate the machine near toxic, dangerous, inflammable and/or explosive powders, fluids or vapors.
When using lead (WET) batteries, battery charging produces highly explosive hydrogen gas. During battery charging,
remove the recovery water tank and perform this procedure in well-ventilated areas and away from open flames.
DANGER!
[MICROMATIC M17E]
Disconnect the cable from the electrical mains before performing any maintenance/repair procedure.
This machine must be used by properly trained and authorized personnel only. Children or disabled people cannot
use this machine.
Do not wear jewerly when working near electrical components.
Do not operate the machine near toxic, dangerous, inflammable and/or explosive powders, fluids or vapors.
WARNING!
[MICROMATIC M17B - MICROMATIC M17E]
Carefully read all the instructions before carrying out any maintenance/repair procedure.
To reduce the risk of fire, electric shock, or injury, do not leave the machine unattended when it is plugged in. Unplug
the machine from the outlet when not in use and before servicing.
To avoid electric shock, do not expose to rain. Store the machine indoors.
Do not allow to be used as a toy. Close attention is necessary when used near children.
Use only as described in this Manual. Use only Advance’s recommended accessories.
Do not use with damaged power supply cable or plug. If the machine is not working as it should, has been damaged,
left outdoors or dropped into water, return it to the Service Center.
If the supply cable or the plug is worn or damaged, it needs to be replaced by the Service Center.
Do not pull or carry the machine by the supply cable; never use the power supply cable as a handle. Do not close
a door on the supply cable, or pull the supply cable around sharp edges or corners. Do not run the machine on the
supply cable. Keep the supply cable away from heated surfaces.
Take all necessary precautions to prevent hair, jewerly and loose clothes from being caught in the machine moving or
vacuuming parts.
Do not work under the lifted machine without supporting it with safety stands.
Do not leave the machine unattended without being sure that the machine cannot move independently.
Do not use the machine on slopes with a gradient exceeding the specifications.
Do not wash the machine with direct or pressurized water jets, or with corrosive substances.
Do not use the machine in particularly dusty areas.
While using this machine, take care not to cause damage to people.
Do not put any can containing fluids on the machine.
The storage temperature must be b32°F and +104°F (0°C and +40°C).
The machine working temperature must be b32°F and +104°F (0°C and +40°C).
The humidity must be between 30% and 95%.
Always protect the machine against the sun, rain and bad weather, both under operation and inactivity condition.
Do not use the machine as a means of transport.
Do not use the machine on slopes with an inclination higher than 2%.
Do not allow the brush to operate while the machine is stationary to avoid damaging the floor.
In case of fire, possibly use a powder fire extinguisher, not a water one.
Do not bump into shelves or scaffoldings, particularly where there is a risk of falling objects.
Do not remove or modify the plates affixed to the machine.
If parts must be replaced, require ORIGINAL spare parts from a Dealer or Authorized Dealer.
The machine must be disposed of properly, because of the presence of toxic-harmful materials (plastic materials,
batteries, electronic boards, etc.), which are subject to standards that require disposal in special centers (see the
Instructions for Use Manual).
If the machine is used according to the instructions, the vibrations do not cause dangerous situations. The machine
vibration level is less than 98.42 in/s2 (2.5 m/s2) (98/37/EEC - EN 1033/1995).
This machine cannot be used on roads or public streets.
Pay attention during the machine transfers when temperature is below freezing point. The water in the recovery tank
or in the hoses could freeze and seriously damage the machine.
Use the brushes and the pads supplied with the machine and those specified in the Instructions for Use Manuals.
Using other brushes or pads could reduce safety.
When lead (WET) batteries are installed on the machine, do not tilt the machine more than 30° from the horizontal
plane to prevent the highly corrosive acid from leaking out of the batteries. If the machine must be tilted to perform
any maintenance procedure, remove the batteries.
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
