Nilfisk-Advance CS7000 Fuel Cell EcoFlex, Service Manual

Page: 91 / 440

Dust Control/DustGuard
™
Systems 91 Service Manual – CS7000
To Clean the Dust Control Filter
Caution: • Wear safety glasses when cleaning the filter.
• Clean the filter in a well-ventilated area.
• Be careful not to puncture the filter element.
1. Check the filter surfaces, and urethane gasket on the bottom of the filter for signs damage. If the filter
surfaces or gasket are damaged, replace the filter.
2. Clean the dust control filter using either of the two methods below:
Method 1:
a. Vacuum any loose dust from the filter.
b. Gently tap the filter against a flat surface (with the dirty side down) to remove loose dust and dirt.
Method 2:
a. Vacuum any loose dust from the filter.
b. Blow compressed air (maximum pressure 100 psi) into the clean side of the filter (in the opposite
direction of the airflow).
To Reinstall the Dust Control Filter
1. Install the
Dust Control Filter
into the
recess in the upper hopper.
Note: Make sure the arrow on the
“
Air Flow
”
Indicator Decal
on the side of the filter is
pointing upward.
2. Install the
Filter Shaker Assembly
onto the
Dust Control Filter
. Make sure the shaker
motor electrical connector is positioned
toward the rear of the machine.
3. Slide the
Filter Shaker Assembly
toward
the right so the
Filter Clamps
engage the
Thumb Nut
studs on the upper hopper.
4. Tighten the two
Thumb Nuts
.
5. Reconnect the
Shaker Motor Electrical
Connector
.
6. Close the hopper cover.
“Air Flow”
Indicator
Decal
Dust
Control
Filter
Filter
Shaker
Assembly
Filter
Clamp (2)
Thumb
Nut (2)