Total Station DTM-322 Instruction Manual
31
Getting Started
3
Qcode observations
To enter the Quick code observation routine, press the
Qcode
softkey.
In this function, you can use the ten numeric keys to
both select a feature code and shoot a point.
To change the measurement mode for the Quick code
observation, press the
Sett
softkey.
[HOT]
key
The HOT key menu is available on any observation
screen. To display the HOT key menu, press
[HOT]
.
Changing the height of the target
To change the height of the target, press
[HOT]
to display
the HOT menu. Then either press
[1]
or select
HT
and
press
[ENT]
.
Enter the height of the target, or press the
Stack
softkey to display the HT stack. The HT stack stores
the last 20 HT values entered.
Setting the temperature and pressure
To set the current temperature and pressure, press
[HOT]
to display the HOT menu. Then either press
[2]
or select
Temp-Press
and press
[ENT]
. Enter the ambient
temperature and pressure. The ppm value is updated
automatically.
Selecting the target set
A target set specifies settings for the target type, the
prism constant, and height of target. When you change
the selected target set, all three settings are changed.
You can use this function to quickly switch between
two types of target, such as a reflector sheet and a
prism. You can prepare up to five target sets.
In Quick code measurement, the Rec mode can only be set to Confirm or ALL.
Summary of Contents for Total Station DTM-322
