Nikon Total Station DTM-322, Instruction Manual, Page: 36 / 185

3 Getting Started
22 Total Station DTM-322 Instruction Manual
2. Press
[^]
or
[v]
to highlight the required
language and then press
[ENT.]
3. The instrument reboots and displays the
start-up
Tilt Telescope screen in the selected
language.
Language Pack #1 is the default Language Pack installed at the factory. Other
Language Packs can be installed at an authorized Nikon total station service provider.
Changing Regional Configuration Pre-sets
To provide easier configuration for common regional settings, you can quickly
configure the Nikon total station to a pre-set combination of default regional settings.
The Regional Configuration screen appears only after the language configuration is
complete, the instrument has rebooted, and the telescope has been tilted. To change
the regional configuration pre-sets:
1. Follow the steps in Selecting a Language, page 21 .
Once the instrument reboots and the
telescope is tilted, the Regional
Configuration screen appears.
2. Press
[^]
or
[v]
to highlight the required
regional settings and then press
[ENT]
.
3. If you do not want to change the current
settings, press
[ESC]
and quit. The instrument will continue to use the last
configured settings that were configured.
The settings affected by the Regional Configuration screen are:
Category Setting Europe International United States
Angle VA zero Zenith Zenith Zenith
Resolution 1"(See note) 1"(See note) 1"(See note)
HA corr. On On On
HA Azimuth Azimuth Azimuth
Distance Scale 1.000000 1.000000 1.000000
T-P corr. On On On
Sea Level Off Off Off
C&R corr. 0.132 0.132 0.132
Coordinates Order ENZ ENZ NEZ
Label ENZ ENZ NEZ
AZ zero North North North