Chapter 3
Assembly
9
5
Assembly for the multi-viewing model by 10 persons
Assemble the system in the order of the numbers ([1] to [17]) in the figure below.
Check that the serial numbers on the two components (on the main section and the relay section) of the MTH
relay unit are identical. (If the numbers are different, observation will be adversely affected. In this case, please
contact your dealer or nearest Nikon representative.) Two sets of MTH relay units are required. Assemble
those components with identical serial numbers to each other.
Check that the serial numbers on the two components (on the main observer’s section and the secondary
observer’s section) of the teaching head S-S are identical. (If the numbers are different, observation will be
adversely affected. In this case, please contact your dealer or nearest Nikon representative.) Four sets of
teaching head S-S are required. Assemble those components with identical serial numbers to each other.
Adjust the height of the support stands so that the main observer section and the secondary observer sections
are horizontal. This step is facilitated by first adjusting the support stands to an approximate height before
attaching the stands.
[9]
Height adjustment
clamp screw
Adjust to an
approximate height
and readjust later.
[4]
Clamp for [5]
Place horizontally
Clamp for
[10]
[3]
Check that the
serial numbers of
the teaching head
S-S are the same.
Clamp for [11]
ND filter (ø28 mm)
[8]
[11]
[7]
Assemble in the
same manner
as that for the
right side.
[5]
[6]
Clamp for [4]
[10]
Clamp for [12]
[12]
[15]
Clamp for
[15]
Place horizontally
[14]
[16]
[17]
Clamp for
[17]
[13]
The lamphouse
gets hot. Attach
the heat protection
shield.
Clamp for
[13]
MTH relay unit
Check that the
serial numbers
are the same.
[1]
[2]
Relay section
Main section