![background image](http://html1.mh-extra.com/html/niko/350-20011/350-20011_quick-manual_1689467014.webp)
350-30010 350-20011
390-20010
14
2.2. Installation
General
- Open the motion sensor by inserting a screw driver in the notch at the
bottom and turn (fig.4).
- Insert the cable in the motion sensor and connect the wires to the
provided terminals. Close the motion sensor.
- Fit the sensors on a wall with the bracket supplied or directly in a corner.
Motion sensor 350-30010
You can easily set the motion sensors by bending the bracket (fig.6). V
indicates the bending angle and M the range in metres (fig.10a). For a
max. range, the sensors have to be fitted flat against a wall (V=0°). The
lens takes into account the necessary inclination to the ground.
Motion sensor 350-20011
When using the sensor in racks, angle the outer motion sensor 45°
(fig.10b). This way, detection outside the rack can be avoided (fig.1b;2b).
2.3. Connection diagrams
- 350-30010 (fig.7)
- 350-20011 (fig.8)
- Parallel connection of motion sensors (fig.9)
Max. 8 sensor per control module, if more motion sensors are
required, provide an additional 24V DC power supply (e.g. 360-37000
or 360-47001).
NOTE: In case of a parallel connection, only one motion sensor can
be connected to the built-in light sensor.
2.4. Cabling
Min. ±0,5mm diameter for a distance of 200m
EN