Nidek Medical SE-9090 Supra, Service Manual

Page: 32 / 350

LLE7D*RDA002B
20
5.2.7 Error 105 (Roughing end error)
Does the lens material which is being processed
correspond to the setting?
No
Replace the lens or change the setting.
Yes
Is the roughing wheel worn out?
Yes
Replace the roughing wheel (see 7.1.27 [p125]) .
No
Does any cable or such interfere with the operation
of the RH axis ASSY (40274-2500) or LH axis
ASSY (40274-2600)?
Yes
Change the route of the cable so that it does not
interfere with the RH axis ASSY (40274-2500) or
LH axis ASSY (40274-2600).
No
Does sufficient cooling water come out?
No
5.6.1 Cooling water does not come out (p79)
Yes
Does the RH axis ASSY (40274-2500) and LH axis
ASSY (40274-2600) move to the right and left
when the buttons are pressed on the hardware test
screen?
No
5.2.32.1 Right processing ASSY does not move
right or left (p45)
5.2.34.1 L spindle block ASSY does not move right
or left (p49)
Yes
Does the lower shaft ASSY (40274-3000) rotate
smoothly when the button is pressed on the
hardware test screen?
No
5.2.36.1 Lower shaft ASSY does not rotate (p53)
Yes
Are there any breaks in the following cable
ASSYs?
Cable ASSY (40274-E028)
Cable ASSY (40274-E029)
Yes
Replace the cable ASSY (40274-E028) or cable
ASSY (40274-E029)
(see 9.3 [p298] and 9.4
[p299]) .
No
Does the brushless motor (40273-E010) rotate?
No
Replace the brushless motor (40273-E010) (see
7.4.1 [p140]) .
Yes
Replace the I/O board (40274-BA06) (see 7.3.4
[p137]) .