Nidek Medical LM-7, Operator'S Manual

Page: 73 / 108

71
4. CONNECTION AND SETTINGS : Operation when Peripheral Devices are Connected
4.1.3 Connecting RT (refractor) or computer
Data to be printed is transmitted to the NIDEK motorized refractor (hereafter referred to as the RT) or
a computer.
LM data transmitted to the RT is used as LM data in subjective test.
LM data transmitted to a computer is managed with various database software.
1
Connect the RT (or a computer) and the LM-7/LM-7P with the communication cable
(optional).
• Connecting to a computer using USB
Connect the optional USB cable between the USB port of the LM-7/LM-7P and that of a com-
puter.
Install the USB driver included with the optional USB cable to the computer.

“4.1.1 Connecting optional cables” (page 68)
2
After measurement, press the print button .
The LM-7/LM-7P transmits the measured data to the RT (or a computer). Then the data is printed.
• When the LM is connected to the RT, it receives a data No. (ID No.) from the RT.
• When the LM is connected to a computer, it does not receive a data No. (ID No.)
• When the LM is connected to the RT, the data No. (ID No.) is also printed.
Connectable equipment RT-2100 / RT-5100
• LM data is transmitted through RS-232C compliant interface.
• Data can be transmitted to a computer through USB.
• The USB interface is in compliant with USB2.0.
• Do not use the commercially available USB cable since the EMC performance may deteriorate (elec-
tromagnetic interference may occur).
• Disconnect the communication cable while pressing the button on the
connector.
When the cable is connected, the button is located on the upside
of the connector.
1707141668223 承認済
Uncontrolled copy when printed.