47
BEFORE USE
:
Device and Software Setup
1
2) Adhere the cap holder on a appropriate place such as a
side of the device.
The cap holder is adhesive-backed. Adhere it after
removing the paper backing.
Place the objective lens cap on the objective lens when the
device is not used, or on the cap holder when the device is used.
3
Connect the power cord to
the inlet of the device.
4
Connect a USB flash drive to the USB connector.
5
If necessary, connect the cables for external devices such as a printer.
6
Confirm that power to the device is turned off (
). Plug the power cord to the power
outlet.
Adhere
Connect the power cord
to the inlet.
CAUTION
• Each time before connecting a USB flash drive to the device, be sure to check it for
viruses.
If the device is infected with a virus and any problem occurs, NIDEK does not assume
responsibility or compensate for damages.
• When connecting the USB flash drive to the device, be sure to perform the procedure
described in “3.1.1 Connection, disconnection, and use of USB flash drive” (Page
140), or with power to the device turned off.
Failure to do so may corrupt the data in the USB flash drive or cause the device to mal-
function.
WARNING
• Be sure to use a grounded power outlet.
Electric shock or fire may result in the event of malfunction or power leakage.
CAUTION
• Be sure to supply power to external devices through an isolation transformer.
