Digistart D3: User Guide
57
Issue: G
8.2 Access Code
Critical parameters (parameter group 15 and higher) are protected by a four-digit security access code, preventing
unauthorised users from viewing or modifying parameter settings.
When a user attempts to enter a restricted parameter group, the keypad prompts for an access code. The access
code is requested once for the programming session, and authorisation continues until the user closes the menu.
To enter the access code, use the
and
M
buttons to select a digit, and the and buttons to change the
value. When all four digits match your access code, press
M
. The keypad will display an acknowledgement message
before continuing.
Enter Access Code
0###
M
Access Allowed
SUPERVISOR
To change the access code, use Pr 15A.
The simulation tools and counter resets are also protected by the security access code.
The default access code is 0000.
8.3 Adjustment lock
You can lock the Programming Menu to prevent users from altering parameter settings. The adjustment lock can be
turned on and off using Pr 15C.
To lock the programming menu:
1. Open the Programming Menu.
2. Open the Advanced Menu.
3. Select 'Restricted'.
4. Enter the Access Code
5. Select Pr 15C
Adjustment Lock
.
6. Select and store 'Read Only'.
If a user attempts to change a parameter value when the adjustment lock is active, an error message is displayed:
Access Denied
Adj Lock is On
8.4 Load defaults
Load Defaults restores the starter to the factory default settings for all parameters except Pr 9A
Language
. This does
not reset the access code.
To load defaults:
1. Open the Programming Menu and select Setup Tools. Enter the access
code.
2. Scroll to the required function and press the
M
button.
Load Defaults
Load Backup
Save User Set 1
3. At the confirmation prompt, select YES to confirm or NO to cancel and
then
M
to load/save the selection.
Load Defaults
No
Yes
When the action has been completed, the screen will briefly display a
confirmation message, then return to the status screens.
