Nidec Control Techniques Digitax-SF DA21223, Instruction Manual, Page: 272 / 386

37
Digitax SF I
nstruction Manual
Operation
６
6. Operation
5. Position Control Mode
5.
Position Control Mode
Homing with
Digitax SF Connect
１．Parameter Tab
Setting homing parameters
2．Point Table Tab
Click Servo ON
（Have the motor in a Servo-ON state）
3．Click Start to start homing
・Click Pause to pause homing
・When homing is completed, the indicator to the left of
the Start button will turn green and the Current position
cell will show the current position resulting from homing.
Start
Stop
Required Parameters
Parameter No. Name Setting
2.0 Control Mode 0 : Position Control Mode
3.0 Command Mode 3 : Internal Command Mode
9.0 Operation Mode
(*)
0 : I/O input
1 : Digitax SF Connect
642.0
Internal Position
Operation Mode
0 : Point Table
Set the operation mode.
*）Operation Mode (No.9.0) = 0 (I/O) upon
drive
power on.
The Setup Panel does not support display or setup of Operation Mode.