TITAN12L1, 912L (w/1050)
Swing Gate System
QUICK START
INSTALLATION
GUIDE
MX4802-01 Rev. B ©2020
1
GATE
6”
11”
Weld or clamp pivot arm on gate hinge post for Pull-to-Open (left) or Push-to-Open (right).
Attach Actuator
to Pivot Arm
Attach Actuator to
Gate Bracket
WASHERS
FIGURE 1:
INSTALLATION OF ACTUATOR TO PIVOT ARM AND GATE BRACKET
GATE
BRACKET
912L ACTUATOR
ENSURE
LEVEL
PIVOT ARM
6”
13”
PIVOT ARM
PIVOT ARM
GATE
GATE
PIVOT ARM:
Push-To-Open
PIVOT ARM:
Pull-To-Open
ACTUATOR AND CONTROL BOX INSTALLATION:
HINGE
POST
HINGE
POST
HINGE
HINGE
GATE BRACKET CENTERLINE
GATE BRACKET CENTERLINE
Pivot Arm
Top of Pivot Arm
TOP VIEW
TOP VIEW
FRONT VIEW
FRONT VIEW
1/2”
1/2”
Pivot
Arm
1B
1A
2
4
PULL-TO-OPEN:
Fully
open gate,
then locate bracket
on gate support.
PUSH-TO-OPEN:
Fully close gate, then
locate bracket on
gate support.
Pull-To-Open
Push-To-Open
Push-To-Open
Pull-To-Open
Bracket Position
Bracket Position
GATE OPEN
Ensure actuator arm is fully retracted, then position gate
bracket on gate structural support as shown below:
GATE CLOSED
TOP OF
PIVOT ARM
Affix Gate
Bracket to
gate struc-
tural support
by welding
or using
bolt/nut.
5
7
8
9
10
ical release open, manually
push gate to desired close
limit, then push to desired
open limit, and then push
to halfway open position.
Close mechanical release,
but do not lock.
actuator and minimum six feet
away from pivot arm (See FIG-
URE 2).
cable through rubber grom-
mets in bottom of control
box and wire per diagram
at right.
For dual gate, dig trench
across drive and run 2nd
actuator cable through con-
duit.
Open mechanical release on actuator.
2
3
1
6
3
CAUTION!
Do NOT weld while control board is powered!
1/2”x
2-7/8”
PIVOT
BOLT
1/2”x3.5”
BOLT
LOCK NUT
LOCK
NUT
Manually Set Limits:
With actuator mechan-
Mount Control Box
same side as primary
Wire actuator to
control board:
Pass
Orange
Orange
White
White
Gr
een
Gr
een
Blue
Blue
Yellow
Yellow
Red
Black
Red
Black
NOTE:
Dual gate: wire Motor 1 and Motor 2 the same way.
E X T R E M E LY
IMPORTANT!
Read entire
manual before
attempting the
installation.
This is NOT a
“do-it-yourself”
project. Use a
qualified con
-
tractor to install
this system.
Read all safety
information!
Place Battery inside
control box with ter
-
minals facing toward the front.
CAUTION!
Do not mount the control box where the person using
the push button on box can come in contact with the gate!
5
5
4
4
3
3
3
3
2
2
2
2
1
1
1
1
