Nice L9BAR, Instructions And Warnings For Installation And Use

Page: 90 / 396

90 – ENGLISH
EN
9.9 CONNECTING THE BOOM LIGHTS (OPTIONAL
ACCESSORY)
To perform the installation:
1. put the boom in the vertical position
2. loosen the 6 screws that fasten the boom cover ( A )
A
57
3. remove the boom temporarily
4. insert the cable grommet through the specially configured
hole ( B )
B
58
5. feed the lights cable ( C ) through the rubber impact
protector and, if necessary, use a fish tape to facilitate the
operation
ST
OP
C
C
59
6. if necessary, shorten the lights cable by cutting it only in
one of the points indicated by an appropriate mark. After
cutting the cable, the cap of the cut end must be shifted
to close the new end
7. insert the wiring cable first through the hole on the boom
support then through the hole in the cubicle
a
leave a bit of cable inside the boom support, so
that the boom can be rotated without causing any
tension along the cable.
60
8. connect the lights cable to the “LIGHT” terminal on the
control unit
m
the “LIGHT” output has poles: if the lights fail to
switch on according to the settings, the cables
connected to the terminal must be inverted.
LIGHT
61