• Choked water seal.
– Check and adjust the condensation water hose.
Only additional heat
If you do not succeed in correcting the fault and are unable to heat the
house, you can put the heat pump in ”add. heat only” mode while
waiting for assistance. This means that the heat pump uses only the
immersion heater to produce heating and/or hot water.
SET THE HEAT PUMP TO ADDITIONAL HEAT MODE
1.
Go to menu 4.2 "op. mode".
2.
Mark ”add. heat only” using the control knob and then press the OK
button.
3.
Return to the main menus by pressing the Back button.
81
Chapter 4 | Disturbances in comfort
NIBE F1255