April 13, 2016
• Edited wording in About this guide to include “shutdown”.
•
Added a note, after the first paragraph in chapter 1, stating that USB Backup/Restore and USB
port functionality is not supported for any JACE-8000 running AX.
•
In the topic, “Creating a USB Backup,” added a similarly worded note above the first step in the
procedure.
•
In the topic, “Restoring from a USB Backup,” added the same note (as that used in the
“Creating...” topic) above the first step in the procedure.
•
In the topic, “Recovering factory defaults,” added a note after the image callouts table, stating
that for any JACE-8000 running AX, USB Backup/Restore and USB port functionality is not
supported. And, that while holding the Backup button during power up/boot up still initiates a
factory recovery image, it restores the controller to its factory ship state which is N4.1, etc.
•
Added the topic, “Shutting down the controller.”
•
Added the topic, “Shutdown operations” under the Reference Information.
December 2, 2015
•
In the USB Backup and Restore feature topic, added a caution about USB drives causing the unit
to fail.
•
In the Create a USB Backup topic, added a caution about USB drives causing the unit to fail.
November 20, 2015
The USB backup restore procedure was updated to reflect a change in the restore options.
October 26, 2015
Changes throughout to reflect Niagara 4.1 updates.
August 18, 2015
Initial release publication.
Related Links
•
About this Guide (Parent Topic)
Related documentation
Additional related information is available in the following document(s).
•
JACE-8000 Mounting and Wiring Guide
•
JACE-8000 Install and Startup Guide
•
Niagara Platform Guide
Related Links
•
About this Guide (Parent Topic)
6
About this Guide
