©
National Instruments Corporation
5
NI SCB-264X Installation Instructions
8.
Attach the ribbon cables to the column and row ribbon cable
connectors. To secure the cables, ensure that the locking mechanism
engages.
Note
The installation location of each cable
must
be consistent with the connections made
inside the NI TB-264
X
. Use the designators on the NI SCB-264
X
printed circuit board to
ensure the correct location of each cable.
LOWER J2
and
LOWER J3
refer to the J2 and J3
connectors on the lower column connection board of the NI TB-264
X
;
UPPER J2
and
UPPER J3
refer to the J2 and J3 connectors on the upper column connection board of the
NI TB-264
X
. If these connections are incorrect, Tables 2 through 10 are invalid.
9.
To connect signal wires to the NI SCB-264
X
, refer to step
Signals
. Otherwise, replace the top cover, and refer to step
the NI TB-264X to the NI PXI-2532
.
Figure 1.
NI SCB-264
X
Shielded Connector Block
1
Top Cover
2
Groove for Screwdriver
3
Strain-Relief Opening
1
3
2
