NF WAVE FACTORY WF1967, Instruction Manual (Operations

Page: 78 / 330

4.4 Setting for Main Items
WF1967/WF1968
4-28
4.4.3 To Set Waveforms
1.
Pressing the FCTN key or using the arrow keys and
modify knob to select [Fctn] will cause the selectable
waveforms above the numeric keypad to light.
At the same time, a selection list of waveforms will
open.
[Fctn] is displayed at first page.
2.
Press the number key corresponding
to the desired waveform or use the
arrow keys and modify knob to select
the waveform and press the ENTER
key.
When you set the waveform as arbitrary wave, the arbitrary waveform stored in the main unit is
selected.

P.4-53
4.4.4 To Set Frequency
1.
Press the FREQ key to open the input field of
Frequency. Or, select the [Frequency] field and
then press the ENTER key.
[Frequency] is displayed at first page.
If [Period] is displayed, press the FREQ key
again or press the soft-key [Freq]. The display
switches to the frequency display.
2.
Select the digit to be changed by using the right or left arrow key, and then use the up or
down arrow key or the modify knob to increment the value. The change is immediately
reflected to the output. Or use the numeric keypad to enter the value.
Press the ENTER key or the unit key (soft-key) ([uHz], [mHz], [Hz], [kHz], or [MHz]) to set
the input value and reflect it to the output. When the ENTER key is used, Hz is set as the
unit.